Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Lincolnwood, IL
Chimney repair in Lincolnwood usually starts with one of two discoveries: a rusted-out damper box on a 1960s ranch, or a cracked clay flue tile found during a pre-sale inspection on a newer in-fill build. Crossroads Chimney Sweep handles both, along with the sweeping and dryer vent work that keeps a Lincolnwood house safe through hard Chicago winters. The housing stock here is tight, compact, and almost entirely built out, which means we see original masonry fireplaces that have gone decades without attention sitting steps away from brand-new factory-built systems with entirely different venting rules. If you have a fireplace that hasn’t been looked at in years, call (877) 265-6720 and we’ll tell you exactly what you’re working with.
Why Lincolnwood Homes Are Different
Lincolnwood is a village of roughly one square mile inside ZIP 60712, and most of the original homes went up between the early 1950s and late 1970s. Those houses, mostly brick ranches, split-levels, and small colonials on tight lots, were built with a single masonry fireplace and a clay-tile flue. Clay tile was the standard then, and it has a real lifespan. After fifty or sixty years of heating and cooling, the tiles crack, the mortar joints between them erode, and the flue starts leaking heat and gases into places they shouldn’t go. Now layer on Chicago weather: freeze-thaw cycles every winter push moisture into exterior brick and chimney crowns, and ice dams at the roofline hold water against the chimney base. What shows up every spring is spalling brick, cracked crowns, and flue damage that wasn’t visible in the fall. On the same street, you’ll often see a teardown replacement with a factory-built fireplace and metal venting. That system has its own inspection and maintenance needs, and it ages differently than a masonry chimney. A technician who only knows one type of system is going to miss things. We work both on the same block, sometimes on the same day.
Styles & brands we work with
Our Main Lincolnwood Services
Homeowners in Lincolnwood call Crossroads for two things most often: getting a wood-burning or gas fireplace swept before winter, and clearing dryer vents that have become a fire hazard. Both are covered in detail on their own pages.
Chimney Sweep in Lincolnwood
Most Lincolnwood homes with an original fireplace have never had a proper sweep, or haven’t had one in a decade or more. On ranches and split-levels from the 1950s and 60s, the creosote buildup is often substantial, and we regularly see original clay flues that look worse on camera than the homeowner expects. We remove the creosote, inspect the flue, and give you a straight answer on whether the chimney is safe to use. See the full scope of the work on our Chimney Sweep in Lincolnwood page.
Dryer Vent Cleaning in Lincolnwood
Tight lots and small utility rooms mean Lincolnwood dryer vents often run longer than they should, with more bends than a vent should have. Lint accumulates in those bends, airflow drops, and the dryer runs hotter and longer. We clean the full vent run, check the termination point, and replace damaged vent components with Famco or Olympia Chimney parts when needed. If your dryer takes two cycles to dry a load, start with our Dryer Vent Cleaning in Lincolnwood page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Lincolnwood
Chimney repair in Lincolnwood follows a pretty clear pattern. On original 1950s and 60s houses, the clay flue has almost always reached the end of its life, and the crown is cracked from decades of freeze-thaw cycling. On newer in-fill construction, the problems tend to come from improper installation or a factory-built system that was never maintained. Either way, the repair starts with a camera inspection so you can see the damage yourself, not just take our word for it. Crossroads Chimney Sweep has served Lincolnwood since 2014, and we stock HeatShield, Gelco, and Olympia Chimney materials so most repairs don’t wait on a parts order. For a deeper look at how we approach repairs, visit our Chimney Repair hub page.
Chimney Cap Installation
Signs you need it
You see rust flakes or water staining around the top of the chimney, or animals have gotten into the flue.
What it costs in Lincolnwood
A new chimney cap installed in Lincolnwood typically runs $180 to $450 depending on the flue size and whether a custom stainless cap is needed.
How we do it
We measure the flue, set a stainless or copper cap with the right mesh size for spark and animal protection, and seal the base properly.
Chimney Liner Installation
Signs you need it
Your camera inspection shows cracked flue tiles, gaps between tiles, or the chimney was built without a liner in the first place.
What it costs in Lincolnwood
A stainless steel liner installation for an average Lincolnwood single-flue chimney runs $2,200 to $4,800, while a HeatShield resurfacing job often falls between $2,500 and $4,500.
How we do it
We run a camera first, then install a properly sized DuraFlex stainless liner or apply HeatShield ceramic resurfacing to restore the flue without a full teardown.
Chimney Flashing Repair
Signs you need it
You have water staining on the ceiling near the chimney, or you can see gaps in the metal where the chimney meets the roofline.
What it costs in Lincolnwood
Flashing repair in Lincolnwood typically runs $350 to $900 depending on whether we’re sealing existing flashing or replacing rotted metal.
How we do it
We remove the old flashing, install new step and counter flashing with the right sealant, and verify the repair with a water test.
Chimney Crown Repair
Signs you need it
You see hairline cracks, crumbling mortar, or pooled water on the concrete cap at the top of the chimney.
What it costs in Lincolnwood
A chimney crown repair in Lincolnwood usually runs $500 to $1,400 depending on whether we’re patching or pouring a new crown.
How we do it
We chip away the deteriorated crown, build a proper form with an overhang and drip edge, and pour it with a weather-resistant mix.
What Chimney Repair Costs in Lincolnwood
| Item | Typical range in Lincolnwood |
|---|---|
| Chimney cap installation | $180 – $450 |
| Chimney flashing repair | $350 – $900 |
| Chimney crown repair | $500 – $1,400 |
| Chimney liner installation (stainless) | $2,200 – $4,800 |
| HeatShield flue resurfacing | $2,500 – $4,500 |
Do I need a new chimney liner or can the old one be repaired?
If the clay tiles are cracked but the flue structure is still sound, HeatShield resurfacing can restore it without a full liner replacement. We’ll show you the camera footage and tell you plainly which option makes sense. Call (877) 265-6720 for an exact quote.
How long does chimney repair take in Lincolnwood?
Most cap, flashing, and crown repairs are done in one visit. A full liner installation typically takes half a day to a full day depending on flue height and access. We’ll give you a firm time window before we start.
Brands We Service in Lincolnwood
We install and service chimneys built with HeatShield, Gelco, Olympia Chimney, and Famco components, and we keep common repair parts on hand locally. That means fewer jobs get delayed waiting on a parts shipment. Visit our brands page to see the full list of what we work with.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Lincolnwood, IL
| Service | Typical range in Lincolnwood |
|---|---|
| Chimney sweep | $180 – $350 |
| Chimney cap installation | $180 – $450 |
| Chimney flashing repair | $350 – $900 |
| Chimney crown repair | $500 – $1,400 |
| Chimney liner installation (stainless) | $2,200 – $4,800 |
| HeatShield flue resurfacing | $2,500 – $4,500 |
| Dryer vent cleaning | $120 – $250 |
Prices push toward the higher end in Lincolnwood when a chimney is unusually tall, inaccessible from the roofline, or hasn’t been swept in so long that creosote removal takes extra passes. Every repair gets a written quote before we start, and the price we quote is the price you pay, no surprise add-ons when we’re already up on the ladder.
Neighborhoods We Serve in Lincolnwood
Because Lincolnwood is compact, we move through the whole village in a single service area and don’t need to batch trips by quadrant. You’ll see us working across the residential blocks near Lincoln and Pratt, the streets around Proesel Park, and the quiet cul-de-sacs south of Touhy. Typical response time here is one to three days depending on the season.
- Near Proesel Park
- The Pratt Avenue corridor
- South of Touhy Avenue
- Blocks around Lincoln Avenue
- The residential streets east of the Edens Spur
Service Area – Cities Near Lincolnwood
Crossroads Chimney Sweep works throughout Chicago’s near north suburbs and the surrounding city neighborhoods. If you’re in West Ridge, IL, Portage Park, IL, Albany Park, IL, or Lincoln Square, IL, we’re close by and familiar with the same housing stock and climate conditions.
Serving Lincolnwood, IL — Our Local Coverage Area
We’re based in the Lincolnwood area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Lincolnwood
Most calls get scheduled within one to three days. In the fall, before the burning season, we run longer on the sweeping side, so call earlier than you think you need to. We’ll always give you a specific appointment window when you book.
Most chimney sweeping, cap installation, and liner replacement work doesn’t require a permit in Lincolnwood, but major structural rebuilds sometimes do. We’ll tell you if your project is one of the exceptions before we begin.
We cover the entire village, ZIP 60712, from the blocks near the Edens Spur to the residential streets along the Chicago border. No part of Lincolnwood is outside our service area.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lincolnwood Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Riya Patel"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Carmen Guzman"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
— Shanice Dawson