Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Elmwood Park, IL
Chimney repair in Elmwood Park usually means one of two things: a cracked clay tile liner that was never sized for a gas furnace, or a spalling brick crown that has been taking on water for a decade. Crossroads Chimney Sweep has served Elmwood Park since 2014, and we see the same story across the village’s 1920s and 1950s brick bungalows and two-flats. Roof pitches here are low, which means most sweeping and repair work happens from the roof rather than a ladder leaning against the gutter line. If you have a chimney question, call (877) 265-6720 and we’ll walk you through what you’re seeing.
Why Elmwood Park Homes Are Different
Elmwood Park sits as a densely packed grid of post-WWII brick bungalows and two-flats, almost all built between the 1920s and 1950s with exterior masonry chimneys. Those chimneys were originally built for coal. When homeowners converted to gas in the decades after the war, most simply ran a new appliance flue through the old clay tile liner and called it done. That creates a specific problem: the liners are undersized for the appliance, and uninsulated against the cold. Freeze-thaw cycles in Elmwood Park winter work on the brick crown and shoulder joints, opening hairline cracks that let rainwater in. By summer, a hard thunderstorm pushes water straight down an uncapped flue and into the firebox. What starts as a simple sweep on a 25-foot lot off Fullerton Avenue frequently becomes a crown repair and cap installation in the same visit. Low roof pitches help us work safely from the roof surface, but tight gangways along 72nd Court and other side streets mean we stage ladders and equipment carefully. Annual inspection is genuinely useful here because the failure points are predictable: crown, cap, liner, flashing.
Styles & brands we work with





Our Main Elmwood Park Services
Most Elmwood Park homeowners call us for one of two things: a chimney that has not been cleaned since the furnace conversion, or a dryer vent that is clogged with lint in a house where the laundry room sits mid-floor with a long horizontal run.
Chimney Sweep in Elmwood Park
Sweeping in Elmwood Park is rarely just about creosote removal. Because so many chimneys carry gas appliance exhaust through old clay tile, we inspect the liner condition on every sweep. Cracked tiles and condensation staining show up often, especially on bungalows where the original coal flue never got relined. Low roof pitches mean we can usually work from the roof surface, which is faster and safer than ladder work on a narrow gangway lot. We sweep, inspect, and give you a straight answer on what needs attention now versus what can wait. If you need a sweep, call (877) 265-6720 or read more about Chimney Sweep in Elmwood Park.

Dryer Vent Cleaning in Elmwood Park
Dryer vents in older Elmwood Park two-flats often run long distances from a mid-floor laundry closet to an exterior wall, and every bend collects lint. A restricted vent makes the dryer run hotter and longer, which is the setup for a lint fire. We clean the full run, check the termination, and use Famco components when a damper or cap needs replacement. It is the same call as a chimney sweep, which is a good reason to do both at the same time. More details on Dryer Vent Cleaning in Elmwood Park.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Elmwood Park

Chimney repair in Elmwood Park follows a pattern. The house was built for coal, converted to gas, and the original clay tile liner stayed in place for sixty or seventy years. Winter freeze-thaw pops the crown joints, summer storms drive water into the flue, and by the time we are called the homeowner has seen a rust stain on the firebox wall or a damp patch on the ceiling near the chimney. Repairs here are usually a combination of crown work, cap installation, and liner evaluation, and the fix is often more affordable than people expect. We carry HeatShield and DuraFlex systems because Elmwood Park houses need real material answers, not caulk. For the full scope of what we repair, see Chimney Repair.
Chimney Cap Installation
Signs you need it
Rain water inside the firebox, rust on the damper, or a visible open flue when you look down from the roof.
What it costs in Elmwood Park
Chimney cap installation in Elmwood Park typically runs $180 to $450 depending on flue size and whether the crown needs a small prep repair first.
How we do it
We measure the flue opening, set the cap with the right attachment for your crown material, and seal the contact points.
Chimney Crown Repair
Signs you need it
Crumbling mortar at the top, spalled brick on the chimney shoulders, or water staining on the ceiling near the chimney chase.
What it costs in Elmwood Park
Crown repair in Elmwood Park generally runs $350 to $900, with the higher end reserved for crowns that need a full rebuild rather than a mortar recoat.
How we do it
We remove loose material, build a new crown surface with the correct slope to shed water, and seal it before the next storm.
What Chimney Repair Costs in Elmwood Park
| Item | Typical range in Elmwood Park |
|---|---|
| Chimney cap installation | $180 – $450 |
| Chimney crown repair | $350 – $900 |
| Chimney flashing repair | $250 – $600 |
Does chimney repair in Elmwood Park require a permit?
Most liner and crown work does not require a village permit in Elmwood Park, but if the repair touches structural masonry or changes the flue configuration, we will tell you before any work starts and help you handle the paperwork.
Can a cracked liner be repaired without tearing the chimney apart?
Yes. HeatShield ceramic resurfacing can restore many cracked clay tile liners from the inside, without demolition or full replacement. We will scope the flue with a camera and show you the exact condition before recommending anything. Call (877) 265-6720 for an honest assessment.
Brands We Service in Elmwood Park
We work with HeatShield for liner resurfacing, Gelco and Olympia Chimney for caps and chase covers, and Famco for dryer vent terminations. Having these materials on the truck means most Elmwood Park repairs are completed in one visit. See our brands for more information.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Elmwood Park, IL
| Service | Typical range in Elmwood Park |
|---|---|
| Chimney sweep (fireplace or wood stove) | $100 – $200 |
| Chimney sweep with gas appliance inspection | $150 – $250 |
| Chimney cap installation | $180 – $450 |
| Chimney cap replacement | $200 – $500 |
| Chimney liner installation | $1,500 – $3,500 |
| Chimney flashing repair | $250 – $600 |
| Chimney crown repair | $350 – $900 |
| Dryer vent cleaning | $150 – $300 |
| Dryer vent repair | $200 – $500 |
| HeatShield liner resurfacing | $1,000 – $2,500 |
Prices in Elmwood Park are pushed up by access issues. A chimney in the middle of a tight two-flat lot with a gangway too narrow for a ladder will cost more than a bungalow with open side yards. You’ll always get the price before we begin, and we do not add charges at the end.
Neighborhoods We Serve in Elmwood Park
We work throughout the 60707 ZIP code and the dense grid of side streets that make up Elmwood Park. Most jobs here are on residential blocks where parking is tight and access is through a shared gangway, so we plan each visit around the specific property layout.
- Fullerton Avenue corridor
- 72nd Court area
- Grand Avenue district
- North Elmwood Park
- South Elmwood Park
We schedule Elmwood Park jobs on a rolling basis, and because our shop is nearby in Belmont Cragin, we are typically able to get to the village within a few days of your call.
Service Area – Cities Near Elmwood Park
Crossroads Chimney Sweep works across the western Cook County villages. If you are just outside Elmwood Park, we also serve River Grove, IL, River Forest, IL, Melrose Park, IL, and Harwood Heights, IL. Call (877) 265-6720 if you are not sure whether we cover your street.
Serving Elmwood Park, IL — Our Local Coverage Area
We’re based in the Elmwood Park area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Elmwood Park
We schedule most Elmwood Park visits within a few days of your call. Because we work from our Belmont Cragin shop, the drive is short, and the low roof pitches on village bungalows mean the on-site work itself runs faster than on steep suburban lots.
Most Elmwood Park homes are not in HOAs, but some newer condo conversions and multi-unit buildings have association rules about exterior work. If you are in one, we can provide a scope of work and material list for your board before the job starts.
Yes. This is exactly what we are built for. One crew can sweep your chimney, inspect the liner, and clean your dryer vent in a single appointment, which saves you a second scheduling headache and catches fire-safety issues across both systems. Call (877) 265-6720 for a free estimate. We are the home chimney and ventilation specialist serving Elmwood Park and the surrounding villages.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Elmwood Park Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Riya Patel"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Carmen Guzman"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
— Shanice Dawson